VERY IMPORTANT NOTE: For customers who purchased vent products before 6/8/2020, please click here for installation instructions. Hole cut outs are a slightly different size than for products purchased after 6/8/2020. Performance and function are not affected.
Intake Vent – Back Wall
The Intake Vent – Back Wall, is a passive vent designed to be easily installed on a back wall of a container / conex for condensation and moisture control. The size (vent area) is designed to feed up to two “360 Wall Exhaust Vents”. The Intake Vent will not fit on the doors.
- Are the part of the “Tunnel Series” air exchange system that provide the fresh air to enter the container and be drawn through by the Exhaust vent (“Driver”)
- Require no moving parts to wear out or require maintenance
- Are screened for debris and pest control
- Are specially designed to fit the individual groove structure of container end or side walls to allow easier and more precise installation.
The Intake Vent - Back Wall, is a passive vent designed to be easily installed on a Back wall of a container. The size (vent area) is designed to feed up to two “360 Wall Exhaust Vents”. The Intake Vent will not fit on the doors.
For questions call or email:
Only logged in customers who have purchased this product may leave a review.